BOGEN PUMPS
Bogen Pumps Industry Co., Ltd
Add to Cart
Non Leakage Pneumatic Diaphragm Pump Good Self Priming Performance 0.83Mpa
Pneumatic Diaphragm Pump Advantage
1. No irrigation water, suction up to 5 meters, head up to 70 meters, the outlet pressure > 7bar
2. Wide flow and good performance, which allows the maximum particle diameter of 10 mm. Pumping mud, impurities, minimal wear and tear on the pump
3. Head, flow through the valve open to realize the stepless adjustment (pressure regulator between 1-7bar)
4. The pump has no moving parts, no seals, diaphragms exhausted medium and pump running parts, working medium is completely separated from the transmission medium does not leak out. So pumping toxic, volatile or corrosive media, will not cause environmental pollution and danger to personal safety.
Pheumatic Membrane Pump Features:
1. Air driven.
2. The pump can not over heating, and no harmful gas discharged.
3. No electric spark.
4. Bigger solids also can be passed and no block.
5. Do not damage solids.
6. Has suction ability.
7. Can empty running without risk.
8. Can works under water.
9. Widely usage, even for the viscous materials.
| Item | Description | Unit | Reference Figure |
| 1 | Maximum air inlet pressure | Mpa | 0.83 |
| 2 | Maximum flow rate | L/Min | 378 |
| 3 | Maximum lift | M | 70 |
| 4 | Maximum outlet pressure | Mpa | 0.83 |
| 5 | Maximum particle size | mm | 6 |
| 6 | Weight | kg | 23 |
| 7 | Noise level | db | ＜70 |
Specifications
Air Diaphragm Pump
1. Non leakage
2. Good self priming performance
3. Convey all kinds of medium
4. Material:Cast steel,Alu,SS,PP
A 40X X - X X X - X (model selection)
Form of pipe mouth:A-BSP B-NPT(F) C-Flange
Diaphragm material:9 – Santoprene H – Hytrel T - PTFE/Santoprene
Ball material:9 -Santoprene H – Hytre T – PTFE A - Acetal
Ball seat material:P/K –Polypropylene/Kynoar SS –Stainless Steel
Pump material: SS –Stainless Steel AL –Aluminum Alloy CI- Carbon Steel P/K –Polypropylene/Kynoar
Maximum Applied Temperature Limits (diaphragm / ball / seal material)
Acetal ···············································40°- 150°F (4.4- 65.5°C)
Santoprene·········································-40°- 225°F (-40°- 107.2°C) ·················································40°- 220°F (4.4°- 104°C) Nitrile··················································10°- 180°F (-12°- 82°C) Viton···················································-40°- 350°F (-40°-176.6°C) Hytrel···················································-20°-150°F (-12°- 93°C) Kynar···················································10°-200°F (-28.9°- 65.5°C) Polypropylene········································32°- 175°F (0-79.4°C)